Intellicut Brand Hypertherm® Style Retaining Cap 220977-i

Intellicut Retaining Cap 220977-i

Intellicut brand, OEM compatible retaining cap for use with Hypertherm® Duramax125® plasma cutter or i-125 plasma torches. These retaining caps are manufactured in Italy to exacting standards, and are 100% OEM compatible. Suitable for hand or mechanized cutting.

The Intellicut brand retaining cap has a quality improvement above the OEM spec, whereby the air flow holes have been optimized for specific amperage ranges instead of utilizing the same hole pattern for 30 amp fine cutting as you would for 125 amp hand cutting.

Features:

• For use with Duramax® HYAMP™ style consumables
• Engineered for maximum life
• Manufactured in Italy to the highest possible standards
• For use in cutting applications up to 160 amps
• OEM Reference part number 220977
• Intellicut code 60311
• Sold as a pack of 1

Options Available:

• Up to 85A (Fine cutting and low amp)
• Up to 160A (general purpose cutting)

Compatible With:

• Hypertherm® Powermax125®
• Hypertherm® H-125 plasma torch
• Intellicut i-125 plasma torch

Legal Disclaimer:

Neither Weldready nor Intellicut is endorsed nor sponsored by the trademark owner Hypertherm® inc. The products seen on this page are high quality aftermarket parts, and are not manufactured by Hypertherm®. The use of the terms Hypertherm®, Duramax®, SmartSYNC®, HYAMP™, and Powermax® are only used as much as necessary to identify the trademark owner as there is no easier way to refer to the products owner.